NEW V2 Vortex Rammer Cold Air Intake System Z06/C6 Corvette 2006+ LS7

New Hot Vortex V2 Rammer for the Z06!!!

Proven on the track and dyno to be the worlds most powerful ram induction system. Holds the record for Nevada high speed event 205 mph. Holds record for bolt on modified C6 at 10.30 @ 134 in 1/4 mile.

1st place winner at BG's BeachBend Raceway for the Air Box challenge 6 years in row !!!

Up to 40+ HP!!! with ram air at high speed. Don't get fooled by the imitators !! Snorkels are for submarines not Corvettes !!! Want to suck water or air !!

Larger Filter Opening Area then or Competitors Snorkel!! Ours 135 sq in  theirs about 40 sq in!!
Our Filtration Surface area measures over 300 sq in!!! That's like a 10"x 30" flat panel filter!!
Proven on the track and dyno to be the worlds most powerful ram induction system. Holds the record for Nevada high speed event 205 mph. Holds record for bolt on modified C6 at 10.30 @ 134 in 1/4 mile.1st place winner at BG's BeachBend Raceway for the Air Box challenge 6 years in row !!!

THE VORTEX RAMMER V2 COLD AIR SYSTEM C6 VETTE

BREATHLESS PERFORMANCE PRODUCTS- This vortex rammer V2 kit replaces the restrictive stock air box assembly. Look closely at the filter and note that this is not the K&N filter that everyone sells. This revolutionary air cleaner contains an internal vortex velocity stack. It obtains cool, pressurized air from the radiator cavity through your modified shroud. Air is forced through a sealed box, where in turn, it directly injects cold air into your intake. (Lowering Manifold Air Temperature by almost 30 Degrees)

Remember, cold air means more power. Our HP results have already shown up to 36HP and 38FT/LBS at the flywheel. Running at speed has give an additional up to 10 more Hp due to the air being forced in.. This is from the benefit of the pressurized air that is created at high speeds (which means there will be more h.p. at speeds over 35 MPH. 1/4 mile tests showed 3 MPH and .30

C6 auto test one showed 26 flywheel HP
C6 stick test two showed 21 flywheel HP

BPP's powerduct is made out of a one piece unit not like our competitors 2 piece seamed units which have a tendency to crack along the seam.

The power duct replaces the stock air bridge between throttle body and MAF.   It increases the air flow to the motor by over forty percent. 

Our new powerduct design of the V2 model is optimized for smooth airflow to the MAF. Our new PowerTube supports the MAF sensor and again is optimized to increase airflow while being computer friendly.

The kits are available in CLEAR, BLACK and CARBON FIBER.
(Clear finish provides a visual access to your Filter and Radiator for service inspection.)